WTB Burma Jeep Parts

jlt1987 · Post by **jlt1987** » Fri Feb 03, 2012 12:40 am

Anyone have Front fenders, driver side running board, inner and outer windshield and any rare stuff, seats, bed, gas tank and spare tire carrier.
Thanks. Charlie

GTBGUY · Post by **GTBGUY** » Fri Feb 03, 2012 12:48 am

Are you looking for an Army GTB or a Navy GTB? Bomb Service or Cargo version? There are differences.

jlt1987 · Post by **jlt1987** » Fri Feb 03, 2012 12:52 am

Sorry about that. It is a navy Cargo version.
Charlie

jlt1987 · Post by **jlt1987** » Sat Feb 04, 2012 2:25 pm

Anyone know where I could get gasket sets for Burma Jeep.
Charlie

motto · Post by **motto** » Sun Feb 05, 2012 1:29 pm

I believe that a straight six Ford engine was used in civilian trucks as an alternate to the V8 side valve. If it was the same engine as used in the GTB then maybe Macs Ford Parts would have them?

The only GTB parts I have are plug lead sets. Some years back a large quantity appeared at a couple of swap meets then they were gone.

David

jlt1987 · Post by **jlt1987** » Tue Feb 07, 2012 4:30 am

I have original SS jerry can , Wehrmacht Watercan and a original BC1000 with battery box and accessories. Will trade for Burma Jeep Parts.
Charlie

Walter · Post by **Walter** » Thu Feb 23, 2012 5:19 am

Hi Charlie:

I have a pretty good selection of GTB mechanical parts. Some of it is used take-off, but the majority of it is NOS still packed in cosmolene I have engine rebuild gasket sets and carb rebuild kits, distrubutors transmission and transfer gears and shafts. Please contact me by private email if you are interested. Also please order by part number if possible as I have cataloged all of the parts by PN.

Sorry, no sheet metal.

My email is l5driver@verizon.net -- Please note the first character is a lower case "L" and not a one or an "I"

Regards,

Walter

jlt1987 · Post by **jlt1987** » Thu Mar 01, 2012 5:04 am

Hi Walter
Sent you a E-mail. Could you send list to vhalftrack@aol.com

Thanks. Charlie

jlt1987 · Post by **jlt1987** » Sat Mar 10, 2012 1:23 pm

Anyone have front seat riser .

Forgotten Field · Post by **Forgotten Field** » Fri Mar 16, 2012 5:23 am

I have a very rough one for pattern. It should give you enough to make one.

jlt1987 · Post by **jlt1987** » Fri Mar 16, 2012 4:50 pm

Forgotten Field
Thanks for your help. Sent you a PM.
Charlie

RESSEM · Post by **RESSEM** » Wed Apr 25, 2012 6:29 pm

there was a ford gtb on craigs list here is the link.
http://killeen.craigslist.org/cto/2944361965.html

jlt1987 · Post by **jlt1987** » Mon May 14, 2012 1:02 pm

Will be picking up another Burma Jeep. This one is 90% complete. It has gas tank, spare tire carrier,brackets for side wood, missing brackets for the fold down seats but it has top bows for cargo bed. Bed is nice has a few bumps and a couple welded on pieces but nothing to bad. Engine compartment is complete and turns over. Windshield has had some pieces welded to it but I have a nice one (Thanks John). Missing passenger seat and top bows for drivers compartment. If anyone has these parts please let me know. Will post photos when I get it.
Charlie

WTB Burma Jeep Parts

WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts

Re: WTB Burma Jeep Parts