ww2dodge.com Forum

I have been looking for a NOS DELCO REMY VOLTAGE REGULATOR DATA PLATE . Cannot find one . Going to get some made . Question is i have 2 types 1 RED ! BLACK I think the RED one is for POS ground . & the black for NEG ground ? IS that right T CORBIN

Ranger may chime in with the differences black/red/early/late/pos/neg. I would be interested in a the 40 amp neg. for a '42. Andy

I too would be interested in several copies of the "40 amp neg.grd"
For what it's worth my originals have a red background ( delco-remy w/pointed end case ) as opposed to the replacement square cased Delco's ( which have a black data plate ) on all my in stock versions.

Thanks
Bud

The 5628 CCKW 25 Amp Pos Ground was black as I remember, can look and see if I have one on the shelf to look at. also I do have 12 V red somewhere. Late Delco w/4 screws was Factory installed starting late 43, and did replace earlier 2 bolt. MY NOS early 2 bolt 40 Amp Neg Ground has black Data plate, as seen in some of my photos.
Not a good idea to be taking covers off perfectly good regulators, as NOS is scarce should the urge to tinker be overpowering.

Hello ,
I make repro of the Delco Remy data plates,
I need confirmation of distance between center of the holes,
so if some one could help...
regards
Robert

Mine are 3-1/2 inches center to center across and 2-1/32 inches center to center up and down. Can you send pics, do you stamp them, and do you have the two correct number font sizes? Andy

New topic about selling these data plates:
viewtopic.php?f=9&t=5963