Page 1 of 1
Dodge WC Engine block or good engine for rebuild
Posted: Thu Jun 29, 2006 7:07 pm
by Mark GB
I'm looking for a good take out motor to rebuild or engine block. Anyone out there have one or know of one. I'm in the UK so would prefer a source over here. However any help grealty appreciated.
Thanks Mark
Posted: Sat Jul 08, 2006 11:49 pm
by Guest
this is an ebay item in the U.S.A. but if you had somebody that could pick it up and send it to you it might be worth it.
then again maybe not.
anyway here is the link.
Bill
120005374391
Posted: Tue Jul 11, 2006 9:05 pm
by Mark GB
Thanks Bill
Anyone out there is Eastern Washington state who could help me out. I'll pay for shipping and donate something for your time!
Thanks Mark
Posted: Tue Jul 11, 2006 9:26 pm
by Mark GB
Opps sorry Western Washingto State! - big place bets thats a few miles difference
Posted: Tue Jul 11, 2006 9:32 pm
by Guest
I am in Western WA. the Tcase is 6x6 dodge or FF PW, the axles are early 1/2 ton. Did you find out if the block is the right number for you? might be a 217. I might be able to pick and drop at a shipper for you find out what town it is in. Steve
Thanks
Posted: Tue Jul 11, 2006 10:47 pm
by Mark GB
I'll find out the engine No - only realy want the engine - axles etc not needed. It seems tryining to find a rebuild motor over here is a bit difficult.
I'll find out what town the guys in.
Thanks again Mark
block
Posted: Wed Jul 12, 2006 2:43 am
by Kaegi
Forgot to put my name on the las post. I know a shipper in Seattle who can pallate whatever you buy and ship for you let me know. I would jsut need gas money. Steve
Thanks everyone
Posted: Wed Jul 12, 2006 7:02 am
by Mark GB
I'm trying to get a reply from the guy.
All I really need is the crank, camshaft, and piston rods (con rods), as i've found a NOS engine block, psitons etc and want to build a new(ish) engine from NOS parts. But been told I wont find a crank, cam and con rods.
Re: Thanks everyone
Posted: Wed Jul 12, 2006 2:00 pm
by Enigma
Mark GB wrote:I'm trying to get a reply from the guy.
All I really need is the crank, camshaft, and piston rods (con rods), as i've found a NOS engine block, psitons etc and want to build a new(ish) engine from NOS parts. But been told I wont find a crank, cam and con rods.
Hi Mark
Did you contact Wildenberg in Holland?
He is going to Beltring.
wildenberg@planet.nl
Thanks Enigma
Posted: Wed Jul 12, 2006 8:05 pm
by Mark GB
no I'll try him - unfortunately I don't think I'll make Beltrng - family 21st B'day and work in the week.
looking to try Sunday early, fingers crossed. I'll get in touch with him via email anyway
Posted: Thu Jul 13, 2006 6:56 pm
by Guest
Mark
Check out this guy he has a lot of parts may be able to help is in the U.S.A.
Bill
http://www.jobrated.com/index.html