Seat measurements

[WC4DOOR]

On the back of the seat there is the sheet metal. At the bottom on each side it has a radius section that transitions from the rails. Does your jump seat have the same pattern? Does the middle and rear seat have the same radius sheet metal pattern? Also in order for the front seat to clear the map table what is the measurement from the top a the seat down to the bottom of the sheet metal?

[WC4DOOR]

Hey look what i found

[WC4DOOR]

[WC4DOOR]

Ok, so if anyone needs the jump seat sheet metal measurements I have them. My next question, is the back sheet metal pattern the same on the drivers, middle, and rear-with the rear being wider? I would imagine that because the seats don’t fold up it shouldn’t matter. I just think it looks more professional with the radius flange.

[Adam in Wa]

1. Yes, all the seat backs have the same transition detail, from the sheet metal backing, to the vertical tubes.

2. Someone has previously cut off the floor mounting legs off my seat, but the legs were 31-1/2 apart, center to center.

3. The rear seat bottom tubes are 45-3/4 wide (outside to outside) and 14-7/16 apart front to back.

[Adam in Wa]

Jump seat:

[Adam in Wa]

I guess my rear seat frame isn’t too bad to save. The bottom springs are shot, but good for dimensions if anyone needs the measurements.

[wc 9 and 12 owner]

I was talking with all American canvas who makes springs into doing period correct seats with springs. He needs examples of all the seats

[WC4DOOR]

Thank you thank you, it’s just what I needed. I have a few more minor detail measurements. I’ll post some pictures.
Thanks again James

[WC4DOOR]

Is the total OD on the back the same as the bottom

[WC4DOOR]

[WC4DOOR]

And one last one, is this tube or flat bar?

[Adam in Wa]

Plate: 3 x 1-3/4, holes are 1-7/8 center to center

Seat frame is 46-3/4 outside to outside.

[Adam in Wa]

Ten inches along the long side.

[Adam in Wa]

Bonus pic: back sheet metal is twenty inches tall.