Page 1 of 1
Carter ETW1 Step up piston Gasket
Posted: Sun Jul 07, 2019 1:19 pm
by G. Miskovsky
All,
Does anyone know if the Carter Carb step up piston gasket is an O-Ring or flat? My rebuild kit did not have one in it.
Re: Carter ETW1 Step up piston Gasket
Posted: Sat Aug 17, 2019 3:10 pm
by Kaegi
pretty sure its flat. not many orings on things back then
Re: Carter ETW1 Step up piston Gasket
Posted: Sun Aug 18, 2019 1:11 pm
by G. Miskovsky
sounds bout right to me...now to find one!
Re: Carter ETW1 Step up piston Gasket
Posted: Mon Aug 19, 2019 1:35 pm
by PareosWC
Gus- is it possible that you take a pic of the 'step up' piston? I just rebuilt my ETW1, and am familiar with where most of the gaskets go..
Re: Carter ETW1 Step up piston Gasket
Posted: Tue Aug 20, 2019 1:09 am
by G. Miskovsky
Sure, as soon as I get back to Fort Sam. TDY this week.
Re: Carter ETW1 Step up piston Gasket
Posted: Sun Sep 01, 2019 2:54 pm
by G. Miskovsky
here is the step up pump
Re: Carter ETW1 Step up piston Gasket
Posted: Wed Sep 04, 2019 5:53 am
by PareosWC
Good morning from Iraq!
Gus, to the best of my knowledge, there are no gaskets in the step up piston assembly. There is, however, one flat one that seats the "receiving" portion of the piston needle. I took that portion to ACE hardware and found the replacement.
http://www.surfacezero.com/g503/showful ... oto=270143
Does that help?
