3/4T rear motor mount bolt config
Posted: Tue Apr 10, 2018 5:39 pm
Gents, I have an immense amount of photos of the WC52 tear down, but didn't manage to get the details on this: before I tighten down the bolt/washer/spring assembly of the rear motor mount, I want to make sure that the order as looking from the top side to down side is as follows:
1. Free running bolt threads
2. Cotter pin
3. Castle nut
4. Washer
5. Spring
4. Cast clutch housing
5. Motor mount
6. Washer
7. Bolt head
Am I missing anything such as another washer or canvas spacer??
1. Free running bolt threads
2. Cotter pin
3. Castle nut
4. Washer
5. Spring
4. Cast clutch housing
5. Motor mount
6. Washer
7. Bolt head
Am I missing anything such as another washer or canvas spacer??