Page 1 of 1
carryall body mounts
Posted: Wed Mar 14, 2018 11:08 pm
by Kaegi
anyone have drawings for the body mounts on a 3/4 ton carryall?
Re: carryall body mounts
Posted: Thu Mar 15, 2018 7:36 pm
by Adam in Wa
I do not have the dimensions, but I think I used 1/2 inch rubber discs b/t the body and frame (except for the front two, which are much taller). Even at that height the body has about an 1/8 inch clearance from rubbing the frame near the front floor pans. There is no issue with the clutch/brake pedals when raising the body, but the starter pedal binds a little bit. Might be easiest for me to raise the engine a little with thicker mounts/bushings.
Re: carryall body mounts
Posted: Sat Mar 17, 2018 3:22 pm
by Bill K.
Kaegi
sent you an email I think been so long can't remember what i'm doing
any more.
Bill K.
Re: carryall body mounts
Posted: Sun Mar 18, 2018 3:54 am
by June J
Hi Kaegi,
John Bizal has the body mount kits in stick, including the lumber front mounts.
Cheers
Ian
Re: carryall body mounts
Posted: Sun Mar 18, 2018 8:52 pm
by Kaegi
Bill K. wrote:Kaegi
sent you an email I think been so long can't remember what i'm doing
any more.
Bill K.
Hey Bill, I didn't see an email. could have got lost in the shuffle.
Re: carryall body mounts
Posted: Sun Mar 18, 2018 11:13 pm
by Bill K.
Well I probably did something wrong.
If John has the mounts that is great he has been doing a lot for the
Dodge people.
If you still want the pic P.M. me your email address.
Bill K.
Re: carryall body mounts
Posted: Mon Mar 19, 2018 5:44 pm
by Bill K.
Kaegi
sent email.
Bill K.