Page 1 of 1
TMs for reference
Posted: Sun Feb 05, 2017 11:39 pm
by krisinwa.st.
I'm finnaly at the point were I can start my ground up restoration of my WC 22 ,
my first order of buisness will be to get TM 10-1123 / 1443 and TM 10-1442 ,
does anybody know if either one of these TMs has the frame diemensions/ specs.
for the 22 frame ? , so I can check it for straight , or are there more plublicatoins
I should look for ? Thanks , Kris
Re: TMs for reference
Posted: Mon Feb 06, 2017 1:09 am
by wc 9 and 12 owner
I have a few spare original copies of the parts and maintenance manuals if you have interest
Re: TMs for reference
Posted: Mon Feb 06, 2017 2:53 am
by zepher11
This is from my TM 10-1153:
Re: TMs for reference
Posted: Mon Feb 06, 2017 5:01 pm
by krisinwa.st.
Hi Zeph , thanks for posting the frame drawing , looks like a non- winch type ?
but I'm sure all the diamensions are the same . Points A-B / C-D / E-F , are reference
points to measure the same . ( ? ) Did you get the radio working for the comand car ?
Kris
Re: TMs for reference
Posted: Tue Feb 07, 2017 2:21 am
by zepher11
No problem Kris. Yes, non-winch frame. Only drawing they have in that TM. I would say all of the measurement reference points are the same.
Regarding the radios. I have built the CH60 Radio Cabinet and rebuilt the junction box. All of the components are coming together. I know the receiver works and the dynamotor. The transmitter is another story as it is missing tubes. Everything will look original on this radio command car with all the suppression components like it did from the factory. Had to make a lot of the components myself. Looks pretty cool with the engine suppression equipment. Have photos on the G503. Now actually getting the radios to work is another story. It may be a retirement project in the future, but that will be a few years away.
