Obvious part that isn't so obvious..
-
PareosWC
- Sergeant
- Posts: 198
- Joined: Mon Jan 11, 2016 12:59 pm
- Location: SC
Obvious part that isn't so obvious..
Gents- what does this bracket go to? I was able to track almost every part of this WC52 build since 2015, but am at a loss for what this supports? Approx 4in in length, 1in wide, and 3.5in holes that are threaded. A winch part, perhaps?
-
motto
- Technical Sergeant
- Posts: 1037
- Joined: Sat Apr 17, 2010 4:25 am
- My garage: Harley Davidson 42WLA, Dodge WC63, Dodge WC57, Chevrolet 1-1/2 ton 4x4. Originally an Earth Borer, Pole Setter. Drilling rig gone and truck now mounts a #7 Set Lifting Frame. i.e.: Light Wrecker.
- Location: 70km from Melbourne Australia
Re: Obvious part that isn't so obvious..
The hole spacing cannot be 3.5" between centres as that would place them 1/4" from the ends of the plate.
If they are 2.5" between centres the plate would, I think be one of a pair that reinforce the cab floor where the diagonal bars attach at the bottom of the "A" pillar. The L/H one is directly above the spare wheel carrier horizontal section.
HTH
David
If they are 2.5" between centres the plate would, I think be one of a pair that reinforce the cab floor where the diagonal bars attach at the bottom of the "A" pillar. The L/H one is directly above the spare wheel carrier horizontal section.
HTH
David
-
Ray Edsall
- Technical Sergeant
- Posts: 1252
- Joined: Fri Apr 07, 2006 6:35 am
- Location: Australia
Re: Obvious part that isn't so obvious..
How about this . The bracket that holds the windscreen hold down lock . From behind the dash board . Could be . Ray
-
PareosWC
- Sergeant
- Posts: 198
- Joined: Mon Jan 11, 2016 12:59 pm
- Location: SC
Re: Obvious part that isn't so obvious..
Hello, David- although my math was off on spacing, you are correct. I have the passenger side installed, but somehow left the driver-side offI think be one of a pair that reinforce the cab floor where the diagonal bars attach at the bottom...
Thank you!