CCKW WINDSHIELD WIPER HOSE NITPICKER

Post Reply
RANGER
1st Sergeant
1st Sergeant
Posts: 6510
Joined: Sat Jul 01, 2006 6:29 pm
Location: Nearest Motor Pool

CCKW WINDSHIELD WIPER HOSE NITPICKER

Post by RANGER »

TRICO manufactured 7/32"ID vacuum hose for the Military, it had a dimpled texture to the outside.
Use of this type hose will most likely gain you some points from a sharp eyed GMC inspector at a show. :wink:
US ARMY HONOR GRADUATE MECHANIC, Restorer of fine Jeeps, MV's, MVPA 40+yrs, DAV, Army Aircrew member, Donor to Military Museums & CAF, MV Hobby since 1945
Other Hobby- Army Air Force & Busting Big Ass Military Imposters-Good at it
RANGER
1st Sergeant
1st Sergeant
Posts: 6510
Joined: Sat Jul 01, 2006 6:29 pm
Location: Nearest Motor Pool

Post by RANGER »

Install a little slack in order that you may cut off 1/2 " when a crack or split appears where the hose attaches to the "Y" or at the Wiper motor.
US ARMY HONOR GRADUATE MECHANIC, Restorer of fine Jeeps, MV's, MVPA 40+yrs, DAV, Army Aircrew member, Donor to Military Museums & CAF, MV Hobby since 1945
Other Hobby- Army Air Force & Busting Big Ass Military Imposters-Good at it
Post Reply