Hi All:
Can anyone lay out some newspaper on the floor and make a full-size trace of a VF-400 series front brush guard so I can fabricate one? I'd buy one if available, but I think the shipping'll be more than the steel material to make one.
Thanks for any help!
-Ken
Want drawing of VF-400 series front brush guard
-
- Technical Sergeant
- Posts: 1611
- Joined: Sat Apr 01, 2006 4:59 am
- My garage: 1941 Dodge WC-43 Telephone Installation (replica)
194? K-38 Telephone Tool Trailer
194? Ben Hur Trailer
1968 Kaiser Jeep M35A2 with winch - Location: Southern California
- Gordon_M
- Lieutenant General
- Posts: 2798
- Joined: Wed Mar 08, 2006 1:43 pm
- Location: Falkirk, Central Scotland
- Contact:
Well,
The good news is that it is exactly the same as the VC one, except the mounting holes are drilled in the lower edge of the VC gaurd and the side of the VF one (to allow for the chassis rails being further apart)
I have a VF gaurd too that I'm going to use on the WD21, but it's buried at the minute, well and truly, and hundreds of miles away.
I do remember that some dealers had a pile of VC or VF guards, so check with VPW and the usual Dodge suspects before you start buying steel bar.
I have a VF gaurd too that I'm going to use on the WD21, but it's buried at the minute, well and truly, and hundreds of miles away.
I do remember that some dealers had a pile of VC or VF guards, so check with VPW and the usual Dodge suspects before you start buying steel bar.
Gordon, in Scotland
( Now officially given up on any form of politics )
( Now officially given up on any form of politics )
-
- Technical Sergeant
- Posts: 1611
- Joined: Sat Apr 01, 2006 4:59 am
- My garage: 1941 Dodge WC-43 Telephone Installation (replica)
194? K-38 Telephone Tool Trailer
194? Ben Hur Trailer
1968 Kaiser Jeep M35A2 with winch - Location: Southern California
-
- Technical Sergeant
- Posts: 1421
- Joined: Mon Oct 30, 2006 3:00 am
- Location: Australia