ETw1 'vent' hole

From VC-1 to WC64-KD.
Posts: 171
Joined: Mon Jan 11, 2016 12:59 pm
Location: SC

ETw1 'vent' hole

Post by PareosWC »

After placing the correct Carter carb on the WC52, I had it idling and responding well to throttle input. However, upon shutdown, I would see a small fuel weep from the 'vent' hole above the mounting stud.

I compared it to another ETW1 I have, and apparently, that's not a manufacturers vent hole :lol: :lol:

Is this a common occurrence? Perhaps poor casting? I can replace it with another good base/governor, but I may JB Weld this small hole.