), front panel is bowed, and the passenger side tool box was torched off.I'm not scared of the rebuild, but if I could save the $$$ by finding a relatively dent free bed, I would consider that.
Anyone have a lead?
WC51/52 beds out there?
-
PareosWC
- Sergeant
- Posts: 199
- Joined: Mon Jan 11, 2016 12:59 pm
- Location: SC
WC51/52 beds out there?
Gents- I'm at the crossroads whether I could rebuild my 3/4T bed, or consider what may already be out there. My composite bed will require a full wood kit with strips/fasteners, holes welded in, panel beating in the rear corners (what gauge steel is that ), front panel is bowed, and the passenger side tool box was torched off.
I'm not scared of the rebuild, but if I could save the $$$ by finding a relatively dent free bed, I would consider that.
Anyone have a lead?
), front panel is bowed, and the passenger side tool box was torched off.I'm not scared of the rebuild, but if I could save the $$$ by finding a relatively dent free bed, I would consider that.
Anyone have a lead?
-
Kaegi
- Technical Sergeant
- Posts: 1515
- Joined: Thu Jan 11, 2007 8:47 pm
- Location: Allyn WA
Re: WC51/52 beds out there?
no sure on the 3/4 ton bed but I think its the same as the WC56/57 body which is 15 gauge
-
Kaegi
- Technical Sergeant
- Posts: 1515
- Joined: Thu Jan 11, 2007 8:47 pm
- Location: Allyn WA
Re: WC51/52 beds out there?
And i think MWM still sells replacement corners with the stampings in them